自上料攪拌車遇到發燙、進水、潮濕返潮、長期連續工作都會引起大大小小的問題，如果出現一絲故障請立馬停止使用。下面來講講自上料攪拌車在運輸過程中需注意的問題。

The self feeding mixer will cause large and small problems in case of scalding, water ingress, moisture regain, and long-term continuous operation. If there is any fault, please stop using it immediately. Now let's talk about the problems that should be paid attention to during the transportation of the self loading mixer.

千萬不能讓自上料攪拌車壞在路上，否則出現悶罐就麻煩了，混凝土一般停罐不能超過2個小時，C40往上級別的混凝土基本就不能停。

Never let the self feeding mixer truck break down on the road, or it will be troublesome if the tank is stuffy. Generally, the concrete can't be stopped for more than 2 hours, and the concrete of C40 level can't be stopped basically.

點火之前先檢查機油、防凍液、潤滑油和冷卻水等，發現不足時，應重新進行添加。車子啟動后，再讓罐子低速旋轉，圍繞著車檢查輪胎氣壓，是否有漏氣的胎，再用螺絲刀剔掉在胎縫里的石子，檢查是否有鐵釘之類扎在胎里!

Before ignition, check the engine oil, antifreeze, lubricating oil and cooling water, and add them again if insufficient. After the car starts, let the tank rotate at a low speed. Check the tyre pressure around the car to see if there is a flat tyre. Then use a screwdriver to remove the stones in the tyre seams and check if there are nails or something!

再檢查燈光，尤其是腰燈，務必保證照著輪胎邊緣，工地會經常亂堆放鋼筋之類的東西，而胎側是薄弱的。用抹布擦干凈兩邊的后視鏡，窗戶玻璃，工地路況復雜，光線不好，視線一定要首先保證!

Check the lights again, especially the waist lights. Make sure to shine on the edge of the tire. The construction site will often pile up reinforcement and other things, and the tire side is weak. Wipe the rear-view mirrors and window glass on both sides with a rag. The road conditions on the construction site are complex and the light is bad. The sight must be guaranteed first!

保證水箱里有足夠的水，有減水劑，因各種原因料太干，沒有水添加放不出料的時候，減水劑就是救命稻草了。確認攪拌罐處于停止狀態，因為發動機啟動時萬一罐子處于高速旋轉狀態，瞬間的力會很大的，傷減速機。

Make sure there is enough water and water reducer in the water tank. The material is too dry for various reasons. When there is no water to add and the material cannot be discharged, the water reducer is a lifesaving straw. Make sure that the mixing tank is stopped, because if the tank is rotating at a high speed when the engine is started, the instantaneous force will be great, which will hurt the reducer.

無論是將手柄從攪拌到排放還是從排放到攪拌，都應使其停止在停止位置，然后撥到下一個操作位置。您還有什么注意事項想得到確認，就來我們網站//wwcoms.com.cn咨詢吧！

Whether the handle is moved from mixing to discharging or from discharging to mixing, it should be stopped at the stop position and then moved to the next operation position. If you want to confirm any other precautions, please come to our website //wwcoms.com.cn Consult!