小型攪拌機為什么會突然熄火呢？有問題就會有原因，只有找到對應的原因，我們才能更好的進行解決，以及做好預防。

Why did the small mixer suddenly shut down? If there is a problem, there will be a reason. Only by finding the corresponding reason, can we better solve it and prevent it.

確定油路暢通，柴油機供給系統沒有空氣后，可拆開油泵蓋板，板動操縱手柄，撥動油泵拉桿，看拉桿是否靈活和柱塞彈簧是否斷裂。

After confirming that the oil circuit is unblocked and there is no air in the diesel engine supply system, the cover plate of the oil pump can be removed, the operating handle can be moved, and the pull rod of the oil pump can be pulled to see whether the pull rod is flexible and whether the plunger spring is broken.

在小型攪拌機拉桿靈活和柱塞彈簧沒斷的情況下，可啟動柴油機中速運轉10分鐘，還有斷火現象時，可用一只銅榔頭輕輕敲擊輸油泵大螺帽，一邊敲一邊聽柴油機聲音，如果聲音不正常，說明輸油泵活塞和推桿發卡，進行修理或更換。

Under the condition that the pull rod of the small mixer is flexible and the plunger spring is not broken, the diesel engine can be started to run at a moderate speed for 10 minutes. If the fire is still broken, a copper hammer can be used to gently tap the large nut of the fuel transfer pump to listen to the sound of the diesel engine. If the sound is abnormal, it means that the piston and push rod of the fuel transfer pump are jammed for repair or replacement.

拆下噴油器總成，轉動曲軸數圈，即有水噴出，說明缸蓋，缸體有裂紋或砂眼，遇到這種情況時，可向用戶解釋或向小型攪拌機公司反映。

Remove the fuel injector assembly and rotate the crankshaft for several cycles, which means that water is ejected, indicating that the cylinder head and cylinder block have cracks or sand holes. In this case, you can explain to the user or report to the small mixer company.

低壓油流暢通后，可用手壓泵排除油路中的空氣，打開泵頭放氣螺釘，直到沒有氣泡時，方可上緊放氣螺釘。

After the low pressure oil flow is unblocked, the air in the oil circuit can be removed by the hand pump, and the air release screw of the pump head can be opened until there is no bubble, then the air release screw can be tightened.

油嘴不霧化，油泵柱塞彈簧和彈簧座斷裂，卡死不工作，或是柴油內有水。拆下油嘴總成檢查開啟壓力和霧化，如果油嘴總成正常，可讓用戶用干凈柴油裝入壺中用油路旁接法進行試驗。

The nozzle does not atomize, the plunger spring and spring seat of the oil pump are broken, stuck and do not work, or there is water in the diesel. Remove the nozzle assembly to check the opening pressure and atomization. If the nozzle assembly is normal, the user can use clean diesel oil to load it into a pot and use the oil circuit side connection method to test.

打開小型攪拌機油箱開關，拆下輸油泵進油管，看油流情況，如果油流很快，說明正常，如果油流時斷時續查油路。

Open the oil tank switch of the small agitator, remove the oil inlet pipe of the oil transfer pump, and check the oil flow. If the oil flow is fast, it indicates that it is normal. If the oil flow is intermittent, check the oil circuit.

小型攪拌機突然熄火的正確解決方法就講解到這里了，您對此有什么想咨詢的問題歡迎來我們//wwcoms.com.cn這里了解！

That's all for the correct solution to the sudden flameout of the small mixer. If you have any questions, please come to us //wwcoms.com.cn Here to understand!